Reese Weight Distribution System with Shank - Trunnion Bar - 10,000 lbs NWT 66540

Reese Weight Distribution System with Shank - Trunnion Bar - 10,000 lbs NWT 66540 Create a stable ride for your tow vehicle and trailer with a weight-distribution hitch. Adding spring bars to your towing system applies leverage, which transfers the load that is pushing down on the rear of your vehicle to all the axles on both your tow vehicle and your trailer, resulting in an even distribution of weight throughout. The result is a smooth, level ride, as well as the ability to tow the maximum capacity of your hitch. Features: Evenly distributes weight over axles of tow vehicle and trailer for stability and control Creates a more level ride for both tow vehicle and trailer Trunnion spring bars are hot rolled and tapered for superior strength and flexibility Bars flex appropriately over uneven terrain for a controlled, even ride Curved ends are designed for use with dual-cam sway control (RP26002 - sold separately) Adjustable spring-bar tension - just switch links in lift chains to fine-tune Desired tilt is easily achieved with serrated-washer design - no more piling on washer after washer Forged, raised ball platform on head eliminates need for raised hitch ball Solid steel shank has corrosion-resistant powder coat System includes head assembly, adjustable shank, lift brackets, trunnion spring bars, lift chains, pin and clip, and all necessary hardware Hitch ball sold separately - requires 1-1/4" diameter shank Specs: Tongue weight: 200 lbs - 600 lbs Gross towing weight: 10,000 lbs Fits: 2" x 2" trailer hitch receivers rated for use with weight-distribution systems Lift-bracket positioning: mount about 30" back from hitch ball Requires approximately 5-1/2" of space along trailer frame Optional mounts (sold separately) that take up less space on a trailer frame are available Will not fit trailer frames wider than 2-1/2" Shank length: 14" from center of hitch pin hole to center of ball hole Total height adjustment along shank: 5-1/4" Maximum rise: 6-1/2" from top of hitch receiver opening Maximum drop: 1-1/4" from top of hitch receiver opening Limited lifetime warranty High-performance system is designed to offer the best in weight distribution with an easy-to-adjust, forged head; a raised ball platform; and flexible, powder coated steel, trunnion spring bars. Adjustable shank included. Hitch ball sold separately. Selecting a Weight-Distribution System The tongue weight rating is the most important factor in determining which size weight-distribution system you should use. If the bars of the system you choose are rated too high for your setup, they will create a rigid ride, which can result in a bouncing trailer. If, on the other hand, the bars are not rated high enough, the system will be unable to properly distribute the weight, rendering it virtually useless. To determine the proper weight rating for a weight-distribution system, you must first determine your trailer's tongue weight. Then add to that the weight of the cargo behind the rear axle of your tow vehicle. These two measurements make up the tongue weight rating for a weight-distribution system. Unique Features of Reese Trunnion-Bar Weight Distribution The easy-to-use, serrated washers on the Reese system make adjusting the tilt of the weight-distribution head a snap. This is a huge improvement over the standard pin-and-washer method, which involves piling washers - one on top of another - onto a difficult-to-access pin. The serrated-washer system lets you easily loosen, adjust and tighten a single washer and nut on either side of the head for simple, secure positioning. Patented Innovative design Forged Integrated Cam One Piece Cast Steel Head Includes shank #54970