Youxmoto HVAC Blower Motor Assembly with Fan Cage AC Heater Blower Motor Fit for Toyota Corolla 1998-2002 700056 8710302021 TO3126105
Item Description

About this item

  • Fitment: The heater blower motor exact match and easy installation fit for Toyota Corolla 1998-2002 (Please MATCH your vehicle model at the left top)
  • Interchange Part Number of Blower Motor Assembly: 8710302021 700056 TO3126105 87103-02021 615-58435 3010097
  • Function: The HVAC blower motor is controlled by the knobs or buttons on the climate control unit. When your heat or A/C is turned on, it is what forces the cold or warm air from your vehicle's A/C or heating system through the interior vents, circulating it throughout the cabin.
  • Simple operation: The operation of a blower motor is relatively simple. When voltage is applied to the electric motor, it spins. In turn, that causes the fan to spin. Since the motor assembly is bolted in place, typically inside a heater box, the fan is able to move relatively large volumes of air at high velocities.
  • Design style: Direct fit replacement parts built to last. Buy with confidence knowing you're buying quality replacement parts from official suppliers.
*The AC Blower Motor is responsible for producing air that goes through the vents of your vehicle's AC and heating system.
*If your AC or Heater does not produce or circulate any heated or cooled air then you may have a problem with your blower motor.
*Step up from the ordinary, It is time to replace the blower motor that has stopped running.
*When you replace the blower motor, it is recommended to replace the new blower motor resistor.
*Please use the year/make/model drop down bar confirm the compatibility before purchasing.

Weak airflow for both the heating and cooled air coming out of the vent
No air pushing through the vents (motor broken down or bad control module)
Unusual blower noise such as a rattle or squeak (worn motor or bad bearings)
If you have an overheating blower motor, would be a burning smell coming from your air vents
Material of rotor punching plate is silicon steel sheet,avoid burning of motor
1.Remove the screws under the passenger side dashboard of the vehicle.
3.Disconnect the blower motor electrical connector.
5.Compare the new blower motor to the old one to verify that you have the correct part.
6.Install the new blower motor into the box and tighten the screws.
8.After the installation is complete, turn on the air conditioner and check if it is running normally.

Payment
We accept payment only through PAYPAL

Shipping
We ship products worldwide through standard express courier service, it will reach within 7 to 10 days to abroad buyers, we ship the product after recieved clear payment and give full information about shipment to the buyer
Return
We accept product return 25 days from delivery date but product should be in original condition.