This listing is for a 16.4ft long IP20 (non waterproof) Epistar 5050 LED light strip with 300 RGB LEDs (each of 300 LEDs is a 3 color RGB Epistar SMD chip

IP 20, non waterproof, (please note: picture shows waterproof version)

Please scroll all way down to see video of this LED strip in automatic color changing mode!

You can set it to emit any monochrome color, any combination of 2 or all 3 (white):  Blue, Red, Green and 4 more combinations R+G=Yellow, R+B=Magenta, G+B=Cyan, R+G+B=White, or various speed dynamic mode using remote control.

These strips are made as flexible printed copper circuit boards less than 1/2" wide and only 1/8" thick in clear waterproof sleeve with 3M self adhesive back. LEDs spaced less than 1-1/4" apart, 9 LEDs per ft. Photos below show snapshots of this strip in color changing mode, with included RGB controller with 433 mHz wireless remote, 12v remote control battery included.  Because remote control operate on RF, there is no need to point it to controller module - it will work through walls, counters etc.

One controller can handle up to two of these strips. These strips are perfect for glass door cabinet lighting, accent, picture and decorative lighting, produce brilliant multicolor or monochrome light you choose! Please do not confuse with low power strips: these are very bright LEDs and you'll need 12 volt power supply capable of at least 6 Amp (6000 mA) output.  Strip shipped with black (positive) and RGB (negative) wire leads and connector attached, it can be cut every 2", each part can be used separately. The expected life span is  100,000 hours.